XLR V8-4.6L VIN A (2006)
Notice: Apply pressure only at the end of the strut actuator that you are removing or attaching. DO NOT apply pressure to the middle of the rod
because damage or bending will result.
6. Lift the link to the full upright position and install the strut actuator (2) to the ball joint (1) on the link.
7. While pushing up on the link, install the travel limit screw (1) to the link.
Tighten the screw to 3 N.m (27 lb in).
8. Install the retainer pin (2) to the hydraulic cylinder.