XLR V8-4.6L VIN A (2006)
11. Remove the locating pin.
Installation Procedure
1. Position the locating pin to the closeout panel.
2. Apply LOCTITE(TM) Blue, GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the bolts.
3. Install the bolts (3) to the locating pin. Do NOT tighten.
4. Apply LOCTITE(TM) Blue, GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the bolts.
5. Position the compartment closeout panel to the vehicle.
6. Install the bolts (1) to the closeout panel. Do NOT tighten.
Notice: Refer to Fastener Notice in Service Precautions.
7. Align the closeout panel bolts (1) to the marks on the link.
Tighten the bolts to 5 N.m (44 lb in).
Important: Align the closeout panels evenly from front to rear. Gaps should exist between the 3 closeout panels.
8. Hold the locating pin into the pin receiver and tighten the locating pin bolts (3).
Tighten the bolts to 5 N.m (44 lb in).
9. Verify that the compartment closeout panel is aligned properly. Refer to Folding Top Clearance Gap Specifications.
10. Adjust the closeout panel if necessary. Refer to Folding Top Storage Compartment Closeout Panel Adjustment - Front Outer.
11. Turn the bypass valve (1) clockwise until the valve stops.
12. Remove the protective covering.