XLR V8-4.6L VIN A (2006)
5. Position the cruise control release switch and bracket to the steering column bracket.
6. Install the bracket bolts to the cruise control release switch.
Tighten the bracket bolts to 12 N.m (106 lb in).
7. Install the brake booster nuts.
Tighten the nuts to 29 N.m (21 lb ft).
8. Connect the master cylinder push rod to the brake pedal.
9. Install the accelerator pedal assembly with accelerator pedal position sensor.
10. Install the left windshield side garnish molding.
11. Install the steering column to the steering column bracket.
12. Install the console.
13. Install the I/P carrier.
14. Connect the negative battery cable and install the cable bolt.
Tighten the bolt to 15 N.m (11 lb ft).
15. Enable the SIR system. Refer to the following procedures in Restraint Systems:
*
SIR Disabling and Enabling Zone 3
*
SIR Disabling and Enabling Zone 4
*
SIR Disabling and Enabling Zone 5
Closeout/Insulator Panel Replacement - Left
Closeout/Insulator Panel Replacement - Left
Removal Procedure