Astro Van 2WD V6-4.3L VIN W (2001)
40. The following conditions must be maintained to properly cure the urethane:
1. Partially lower a door window in order to prevent pressure buildups when closing doors before the urethane adhesive cures.
2. Do not drive the vehicle until the urethane adhesive is cured. Refer to the above curing times.
3. Do not use compressed air in order to dry the urethane adhesive.
41. Connect the electrical connector to the rear window defogger on the liftgate window.
42. Install the liftgate window garnish molding. Refer to Liftgate Garnish Molding Replacement () in Body Rear End.
43. Close liftgate window.
44. Install the back window wiper arm to the liftgate. Refer toRear Window Wiper Arm Replacement in Wipers/Washer Systems.
45. Connect the washer hose to the liftgate.
46. Remove the protective coverings and tape from the vehicle liftgate and headliner.
