chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Rear Door Latch > < Outside Handle and Lock Cylinder|Page 7327
Page 2
background image

1. Clips to the handle.
2. Inside handle to the door.
3. Inside handle screws.
4. Control rods to the handle and the clips.
5. Door trim panel.

Outside Handle

Remove or Disconnect

1. Door trim panel.
2. Control rods from the handle. Pry the clip anchor out of the hole, and push the clip away from the lever. Pull the rod and the clip away from the

lever.

3. Outside handle nuts.
4. Outside handle from the door.

Install or Connect

1. Clips to the handle.
2. Outside handle to the door.
3. Outside handle nuts.
4. Control rods to the handle and the clips
5. Door trim panel.

Rear Door Latch > < Outside Handle and Lock Cylinder|Page 7327