Avalanche 1500 2WD V8-5.3L (2008)
9. Remove the brake caliper and the bracket as an assembly and support with heavy mechanics wire or equivalent.
10. If installing the original brake rotor, mark the relationship of the rotor to the hub.
11. Adjust the park brake so that the adjuster is fully seated.
12. Remove the push nuts from the brake rotor if necessary.
13. Apply a small amount of penetrating oil to the wheel studs.
14. Install the lug nuts on the end of the wheel studs.
15. Using a dead blow hammer, tap the brake rotor between the wheel studs.
16. Remove the lug nuts from the wheel studs.
