Aveo L4-1.6L (2008)
Important
The spring clamp to the PCV valve should be located with the spring towards the intake manifold to prevent damage to the breather
hose.
18. Removed in Step 18.1 - Install the spring clamps with the short coolant inlet hose to the throttle body and the other end to the PCV valve (1).
19. Remove the EVAP hose (3) from the intake manifold vacuum port (1) and from both retainers at the bottom of the intake manifold (2, 4).
Remove the retainer from the stud bolt at the bottom lower left side of the intake manifold (1). Refer to Step 10 for the removal procedure of the stud
bolt (1). Save the retainer for use later in the procedure.
Important
