Aveo L4-1.6L (2008)
Ensure that the retainer's larger slot is at the bottom of the intake manifold as shown (3).
20. Install the new MAP sensor bracket (1) with a new bolt/screw and the retainer (2) to the bottom of the intake manifold.
Tighten
Tighten the MAP sensor bracket bolt/screw to 10-12 Nm (90 lb in).
Install the EVAP hose to the intake manifold vacuum port (4) and to both retainers at the bottom of the intake manifold (3).
Important
The MAP sensor hose and bracket position (4) is critical. The hose should not contact the MAP sensor bracket. Refer to the illustration
above.
21. Install the MAP sensor (2) on the new MAP sensor bracket with a new bolt/screw (1) and connect the MAP sensor wiring harness connector (3).
The MAP sensor connector should be oriented at a 5 o'clock position relative to the intake manifold with the harness (3) positioned toward the
front of the vehicle as shown above.
Tighten
Tighten the MAP sensor bolt/screw (1) to 10-12 Nm (90 lb in).
1. Install the MAP sensor vacuum tube assembly between the lower port on the intake manifold (5) and to the underside of the MAP sensor (4).
Ensure that the larger end of the vacuum tube assembly (5) is oriented toward the intake manifold vacuum port as shown above.
2. Install the intake manifold vacuum hole plug on the remaining open intake manifold port (6) as shown above.
Important
The spring clamp should be located with the spring towards the intake manifold to prevent damage to the breather hose.
22. Install the original spring clamp and coolant outlet hose removed in Step 18.2 to the new PCV valve assembly port (1).
23. Install the original spring clamp and coolant outlet hose removed in Step 18.2 to the coolant surge tank (1). If equipped, install a new tie strap to
