C 2500 Truck 2WD V8-5.7L VIN R (1997)
A. Align the holes in the driveshaft support with those in the drive housing.
B. Make sure that the driveshaft support is fully seated in the drive housing and that the driveshaft bearing remains fully seated in the driveshaft
support.
3. Shift lever screw, washer, and nut.
Tighten
-
Shift lever nut to 4.5 N.m (40 lb in).
4. Plate, if used, and drive housing plug to the drive housing.
5. Washers in the same number and position as noted at disassembly.
6. Armature support bracket to the drive housing.
-
Align the mark made prior to disassembly with that on the drive housing.
7. Drive housing bolts.
Tighten
-
Drive housing bolts to 8.5 N.m (75 lb in).
Frame, Field, and Brush Holder Group
Electrical Group
Brush Spring On The Post
Springs And Brushes On The Brush Holder
INSTALL OR CONNECT
