C 2500 Truck 2WD V8-5.7L VIN R (1997)
5. Outside handle mounting bolts.
Tighten
^
Bolts to 4 N.m (35 lb in).
6. Inner mounting panel assembly.
7. Water deflector.
8. Trim panel.
Window Regulator Handle
Window Regulator Handle & Bearing Plate
Tool Required:
J 9886-01 Door Handle Remover
Remove or Disconnect
1. Window regulator handle from vehicle.
A. Insert J 9886-01 between the handle and bearing plate.
B. Align the tool and push to disengage the clip.
C. Pull the handle from door.
2. Bearing plate.
Install or Connect
1. Bearing plate to door.
2. Window regulator handle.
A. Raise window.
B. Install the clip onto the handle.
C. Insert handle onto window regulator shaft so the handle is pointing toward the front of the door.
D. Push on the handle until the clip engages window regulator shaft.
