C 2500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2001)
1. Install and connect the fuel lines to the clips (3) on the fuel tank.
2. Connect the fuel lines to the sending unit.
3. Install the fuel tank.
Engine Compartment (FICM to Filter )
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative battery cables from both batteries.
2. Remove the fuel tank cap.
3. Remove the clamps and rubber fuel hose from the fuel filter to the fuel injector control module (FICM) module.
INSTALLATION PROCEDURE
1. Install the hose and clamps.
2. Install the fuel tank cap.
3. Connect the negative battery cables to both batteries.
4. Prime the fuel system at the fuel manager 30 times to purge the air out of the hoses.
5. Start the engine and check for leaks.
Engine Compartment (FICM to Fuel Injection Pump)
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative battery cables from both batteries.
2. Remove the fuel tank cap.
3. Remove the clamps and rubber fuel hose from the FICM module to the fuel injection pump.
INSTALLATION PROCEDURE
1. Install the hose and clamps.
2. Install the fuel tank cap.
3. Connect the negative battery cables to both batteries.
4. Prime the fuel system at the fuel manager 30 times to purge the air out of the hoses.
5. Start the engine and check for leaks.
Engine Compartment (Fuel Injection Pump to Y Junction)
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative battery cables from both batteries.
2. Remove the fuel tank cap.
3. Remove the clamps and rubber fuel hose from Y junction to the fuel injection pump.
INSTALLATION PROCEDURE
1. Install the hose and clamps.
2. Install the fuel tank cap.