C 2500 Truck 2WD V8-6.6L DSL Turbo VIN 1 (2001)
3. Connect the negative battery cables to both batteries.
4. Prime the fuel system at the fuel manager 30 times to purge the air out of the hoses.
5. Start the engine and check for leaks.
Fuel Feed and Fuel Return Pipe Purge Procedure
FUEL FEED AND FUEL RETURN PIPE PURGE PROCEDURE
1. Pump Primer located on top of the fuel filter 30 times or until stiff.
2. Attempt to start and run the engine. If the engine does not start, repeat step 1.
3. Allow to run for 5 minutes at idle.
4. Check for fuel leaks.
5. Clear all engine diagnostic trouble codes (DTCs).
Fuel System Priming
Fuel system priming procedures can be found under Fuel Delivery and Air Induction system service procedures. See: Service and Repair/Fuel System
Priming