C 3500 HD Truck 2WD V8-6.5L DSL Turbo VIN F (2001)
Door Module: Service and Repair
Door Lock Inversion Module Replacement
REMOVAL PROCEDURE
1. Rotate the I/P assembly forward. Refer to IP Assembly - Rotating in Instrument Panel, Gauges and Console.
IMPORTANT: The green box is not replacable, Only the circuit board inside the box is serviceable.
2. Untape the inversion module green box(1) that is secured to the wiring harness to allow access.
3. Open the inversion module door and remove the circuit board.
4. Remove the inversion module circuit board(1) from the vehicle.
INSTALLATION PROCEDURE
1. Install the inversion module circuit board(1) into the green box and close the cover.
2. Resecure the inversion module green box(1) to the wiring harness in its original position.
3. Reinstall the I/P by rotating back to its original position.
