C 3500 Truck 2WD V8-6.0L VIN U (2001)
Notice: All camshaft journals are the same diameter, so care must be used in removing or installing the camshaft to avoid damage to the camshaft
bearings.
3. Using the bolts as a handle, carefully install the camshaft into the engine block.
4. Remove the three bolts from the front of the camshaft.
Important: Install the retainer plate with the sealing gasket facing the engine block.
The gasket surface on the engine block should be clean and free of dirt and/or debris.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the camshaft retainer and bolts.
^
Tighten the camshaft retainer bolts to 25 Nm (18 ft. lbs.).
6. Inspect the camshaft sensor O-ring seal. If the O-ring seal is not cut or damaged, it may be reused.
7. Lubricate the O-ring seal with clean engine oil.
8. Install the camshaft sensor and bolt.
^
Tighten the camshaft sensor bolt to 25 Nm (18 ft. lbs.).
9. Install the timing chain and camshaft sprocket.
10. Install the valve lifters.
11. Install the radiator support.