Camaro V8-5.7L VIN G (1998)
Then, repeat the previous five steps.
Tighten the ABS hydraulic modulator bleeder valves to 9 Nm (80 inch lbs.).
18. Remove the brake fluid reservoir cover.
19. Inspect the brake fluid level in the reservoir. Fill the reservoir to the correct level if necessary.
20. Install the brake fluid reservoir cover.
21. Turn the ignition switch to the RUN position. Apply the brake pedal with moderate force and hold. Note the pedal travel and feel.
21.1. If the pedal feels firm and constant and pedal travel is not excessive, start the engine.
21.2. With the engine running, recheck the pedal travel.
21.3. If the pedal still feels firm and constant and pedal travel is not excessive, road test the vehicle.
Make several normal (non-ABS) stops from a moderate speed in order to ensure proper brake system function. Allow adequate cooling time
between stops.
22. If pedal feels soft or has excessive travel either initially or after starting the engine, repeat previous procedures:
23. Road test the vehicle. Make several normal (non-ABS) stops from a moderate speed in order to ensure proper brake system function. Allow
adequate cooling time between stops.
