Camaro V8-6.2L (2010)
2. Install the NEW rear housing gasket (1), rear housing with seal (2), rear housing to engine bolts (3) and oil pan to rear housing bolts (4).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Tighten the rear housing to engine bolts (3) until snug. Do not overtighten. Tighten the oil pan-to-rear housing bolts (4) to 12 Nm (106 lb in).
4. Tighten the rear housing to engine bolts (3) to 30 Nm (22 lb ft).
5. Remove the J 41479-2A.
6. If equipped with automatic transmission, install the automatic transmission flexplate. refer to Automatic Transmission Flex Plate Replacement (
See: Transmission and Drivetrain/Flex Plate/Service and Repair).
7. If equipped with manual transmission, install the flywheel. Refer to Camshaft Replacement (See: Camshaft, Lifters and Push
Rods/Camshaft/Service and Repair/Camshaft Replacement).
Installation Procedure - Cover without Seal
1. Position a NEW rear oil seal housing gasket (3) and the housing (2) to the engine.
2. Install the rear oil seal housing bolts (1) until snug. Do not overtighten.
3. Rotate the crankshaft until 2 opposing flywheel bolts holes are parallel to the oil pan surface.
