chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Crankshaft, Engine > < Crankshaft Seal Retainer|Service and Repair|Page 1941
Page 5
background image

Note:  The tapered legs of the alignment tool must enter the rear cover oil seal bore.

4. Install the J 41476 and bolts onto the rear of the crankshaft.
5. Tighten the J 41476 bolts until snug. Do not overtighten.

6. Install the oil pan to rear oil seal housing bolts (1).

1. Tighten the oil pan to rear cover bolts to 12 Nm (106 lb in).
2. Tighten the rear oil seal housing to engine bolts to 30 Nm (22 lb ft).

7. Remove the J 41476.
8. Install a NEW crankshaft rear oil seal. Refer to Crankshaft Rear Oil Seal Replacement   (See: Seals and Gaskets/Crankshaft Main Bearing

Seal/Service and Repair).

9. If equipped with automatic transmission, install the automatic transmission flexplate. refer to Automatic Transmission Flex Plate Replacement   (

See: Transmission and Drivetrain/Flex Plate/Service and Repair).

10. If equipped with manual transmission, install the flywheel. Refer to Camshaft Replacement   (See: Camshaft, Lifters and Push

Rods/Camshaft/Service and Repair/Camshaft Replacement).

Crankshaft, Engine > < Crankshaft Seal Retainer|Service and Repair|Page 1941