Camaro V8-6.2L (2010)
9. Remove the blower motor nuts.
10. Remove the blower motor from the blower motor cup.
Installation Procedure
1. Clean / smooth the rough edges / burs of plastic from HVAC module case where original molded in place blower was cut out.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Attach blower service ring using service screws.
Tighten the nuts to 2.4 Nm (21 lb in).
3. Install blower motor with service ring assembly into position on the HVAC module, and attach service ring to HVAC module case with additional
service screws
4. Install the blower motor.
