Camaro V8-6.2L (2010)
Power Steering Line/Hose: Service and Repair
Fluid Cooler Outlet Hose Replacement
Fluid Cooler Outlet Hose Replacement
Removal Procedure
1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement (See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine
Performance Checks/Air Cleaner Housing/Service and Repair) for the V6 engine or to Air Cleaner Assembly Replacement (See: Engine, Cooling
and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and Repair) for the V8 engine.
2. If equipped with the V6 engine, cover the air conditioning compressor in order to prevent power steering fluid from dripping on the air
conditioning compressor.
If equipped with the V8 engine, cover the generator in order to prevent power steering fluid from dripping on the generator.
3. Place drain pans under the vehicle.
Caution: Do not start the vehicle with any power steering gear inlet or outlet hoses disconnected. When disconnected, plug or cap all openings of
components. Failure to do so could result in contamination or loss of power steering fluid and damage to the system.
Note: Introducing too much air into the power steering system will increase the amount of time required to bleed the system. Maintain the fluid
level during this procedure.
4. Disconnect the power steering fluid cooler outlet hose (2) from the power steering fluid reservoir (1). Cap the power steering fluid reservoir inlet
port. Plug the power steering fluid cooler outlet hose.
5. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Wheels and Tires/Vehicle Lifting/Service and Repair).
