chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Rear Door Window/Handle - Revised Service Procedure|Page 10349 > < Body - Vehicle Glass Distortion Information
Page 1
background image

Technical Service Bulletin # 631038

Date: 960801

Rear Door Window/Handle - Revised Service Procedure

File In Section: 10 - Body 

Bulletin No.: 63-10-38

Date: August, 1996

SERVICE MANUAL UPDATE

Subject: 
Revised Service Procedures for Rear Door Window Regulator and Rear Door Outside Handle

Models: 
1994-96 Chevrolet Caprice, Impala SS

This bulletin is being issued to revise information for the rear door window regulator and rear door outside handle service procedures in Section 10-6 of
the Service Manual.

To service the rear door window regulator, it is necessary to remove the door armrest support, which is not mentioned in the Service Manual. To service
the rear door outside handle, it is necessary to remove the door armrest support and the locking system module which is not mentioned in the Service
Manual. Listed below are the updated procedures for each component.

Important

The following labor times have been updated to reflect the revised procedures:

Labor

Labor

Operation

Description

Time

B4520/21

Rear Door Outside Handle

1.0 hr

C0380/81

Rear Door Manual Window

1.3 hrs

Regulator

C0382/83

Rear Door Power Window

1.3 hrs

Regulator

Rear Door Window Regulator

Remove or Disconnect

1.

Rear side door trim. Refer to "Rear Side Door Trim".

2.

Rear side door armrest support by drilling out rivets.

3.

Rear side door water deflector by peeling away from door.

Caution

Tape rear side door window to rear side door frame. If rear side door window drops into rear side door personal injury or rear side door
window damage may result.

4.

Support rear side door window in the position needed to access regulator-to-window sash rivets, by taping window to door frame using a cloth
backed tape.

5.

Rear side door locking system module. Refer to "Rear Side Door Locking Module".

6.

Rear side door window regulator-to-window sash rivets using a 5/16 inch drill bit.

7.

Bolts securing regulator cam to door inner panel.

8.

Window regulator electrical connector, if power window regulator.

9.

Window regulator-to-door rivets.

10.

Window regulator reinforcement, if manual window regulator.

11.

Window regulator from door.

Rear Door Window/Handle - Revised Service Procedure|Page 10349 > < Body - Vehicle Glass Distortion Information