Caprice V8-265 4.3L VIN W MFI (1995)
^
The window regulator and motor are serviced as a unit.
Install or Connect
1.
Window regulator to door.
2.
Window regulator reinforcement, if manual window regulator.
3.
Window regulator-to-door rivets.
4.
Window regulator electrical connector, if power window regulator.
5.
Bolts securing window regulator cam to door inner panel.
6.
Rear side door window regulator-to-sash rivets.
7.
Rear side door locking system module. Refer to "Rear Side Door Locking System Module".
8.
Remove tape securing window to door frame.
9.
Rear side door water deflector.
10.
Armrest support and rivets.
11.
Rear side door trim. Refer to "Rear Side Door Trim".
Rear Side Door Outside Handle
Remove or Disconnect
1.
Fully raise window.
2.
Rear side door trim. Refer to "Rear Side Door Trim".
3.
Armrest support by drilling out rivets.
4.
Peel back upper edge of water deflector.
5.
Rear side door locking system module rivets and screws.
6.
Move rear side door locking system module downward and forward until the outside handle rod is visible through the door lock opening.
7.
Disconnect handle rod from handle by inserting a flat bladed tool through the door lock opening and unclipping retainer.
8.
Door locking system module from door.
9.
Outside handle nuts.
10.
Outside handle from door.
11.
Outside handle rod from locking system module.
Install or Connect
1.
Outside handle rod to handle using a new retainer.
2.
Hold handle in the open position and install into door.
3.
Outside handle nuts.
Tighten
Tighten outside handle nuts to 5 N.m (44 lb in.).
4.
Door locking system module, screws and rivets. Do not connect outside handle rod at this time.
