Cavalier/Z24 L4-138 2.3L DOHC VIN D MFI (1995)
Figure 14
Figure 15
Remove or Disconnect
1. Wiper arm assemblies from wiper transmission assembly drive shaft.
2. Four screws (15), five retainers (16), and air inlet screen assembly (17) from vehicle.
3. Connector (18) from wiper motor assembly (19).
4. Three screws (20) and wiper drive system module (21) from vehicle.
5. Wiper transmission assembly (22) from wiper motor crank arm assembly (23) using tool J 39232.
6. Wiper motor crank arm assembly (23) from wiper motor assembly (19).
A. Loosen screw (24).
B. Tap on screw (24) with a soft-faced mallet while holding up on wiper motor crank arm assembly (23) until wiper motor crank arm assembly
(23) is loose on wiper motor assembly (19).
C. Remove screw (24) and wiper motor crank arm assembly (23) from wiper motor assembly (19).
7. Three screws (25) and wiper motor assembly (19) from tube frame (26).
Install or Connect
NOTICE: Refer to Fastener Notice.
1. Wiper motor assembly (19) on tube frame (26) with three screws (25).
Tighten
^
Screws to 7 N.m (62 lb. in.).
2. Wiper motor crank arm assembly (23) on wiper motor assembly (19).
A. Connect connector (18) to wiper motor assembly (19).
B. Put ignition switch in "ACCY" position.
C. Set wiper switch to "PULSE" position. Wiper motor assembly (19) should be operating.
