Cavalier/Z24 L4-138 2.3L DOHC VIN D MFI (1995)
D. Turn off ignition switch while wiper motor is stopped in innerwipe position.
E. Disconnect connector (18) from wiper motor assembly (19).
NOTICE: Do not rotate wiper motor assembly shaft during installation of wiper motor crank arm assembly.
F. Install wiper motor crank arm assembly (23) on wiper motor assembly (19) while maintaining a 4-8 mm (.157 - .315 in.) gap between wiper
motor crank arm assembly (23) and bracket tab (F).
G. Install screw (24).
H. Check gap between wiper motor crank arm assembly (23) and bracket tab (F). If gap is not 4-8 mm(.157-.315 in.)remove crank arm assembly
(23) and repeat installation step 2.
Tighten
^
Screw to 16 N.m (144 lb. in.).
3. Wiper transmission assembly (22) on wiper motor crank arm assembly (23) using tool J 39529.
4. Wiper drive system module (21) on vehicle with three screws (20).
Tighten
^
Screws to 10 N.m (88 lb. in.).
5. Connector (18) on wiper motor assembly (19).
6. Screen assembly (17) on vehicle with four screws (15) and five retainers (16).
7. Wiper arm assemblies on wiper transmission assembly drive shaft.
8. Operate wipers and check for proper operation.
