Celebrity V6-173 2.8L (1989)
Brake Pad: Service and Repair
Installation
TAB Mount
Fig. 9 Installing Retainer Spring On Inboard Shoe
Fig. 10 Positioning Screwdriver Between Outboard Shoe Flange & Hat Section Of Rotor
Fig. 11 Positioning Hammer To Clinch Brake Pad Tabs
1. Lubricate new bushings with suitable grease, install bushings in caliper grooves, then insert sleeves through bushings.
2. Install retaining spring onto inboard shoe and lining assembly if equipped, then install inboard shoe into caliper housing. Shoe must lay flat against
piston.
3. Install outboard shoe and lining assembly into caliper housing ensuring wear sensor is properly positioned. Back of shoe must lay flat against
caliper.
4. Install caliper assembly. Refer to Caliper Removal. See: Brake Caliper/Service and Repair/Caliper Removal
5. Apply brakes several times to ensure caliper piston is extended and shoes are fully seated.
CINCHING PROCEDURE
1. Wedge a large flat blade screwdriver between outboard shoe flange and hat section of rotor.