Cobalt L4-2.0L SC VIN P (2005)
3. Using a hydraulic jack, raise the transmission until it contacts the transmission mount.
4. Important: The transmission mount to transmission bolts must be hand started. Do not pry the transmission or mount to align the holes.
Hand start the transmission mount to transmission bolts using the following sequence:
1. Rear Bolt
2. Middle Bolt
3. Front Bolt
5. Using the previous sequence, tighten the transmission mount bolts.
^
Tighten the bolts to 50 Nm (37 ft. lbs.).
6. Reposition the under hood electrical center.
7. Connect the wiring harness retainer to the tray bracket.
