Colorado 2WD L4-2.8L VIN 8 (2004)
Body Emblem: Service and Repair
Emblem/Nameplate Replacement - Pickup Box (Colorado)
Emblem/Nameplate Replacement - Pickup Box (Colorado)
Tools Required
J 25070 Heat Gun
Removal Procedure
Important: Use the tape for protection and alignment marks for alignment of the new decal.
1. Apply tape to the area around the decal.
2. Heat the decal, using a J 25070, 152 mm (6 in) from the surface.
3. Apply the heat using a circular motion for about 30 seconds.
Notice: Refer to Exterior Trim Emblem Removal Notice in Service Precautions.
4. Remove the decal from the painted surface using a plastic, flat-bladed tool.
5. Remove all adhesive from the painted surface using 3M(TM) ScotchBrite molding adhesive remover disk 3M(TM) P/N 07501 or equivalent.
6. Clean the painted surface using varnish makers and painters (VMP) naptha.
7. Remove the tail lamp.
Installation Procedure