Colorado 2WD L4-2.8L VIN 8 (2004)
1. If the location of the decal has not been marked, apply tape and use the following dimensions:
*
Dimension (a) is 207.1 mm (8.15 in) from the top edge of the pickup box to the highest point on the decal.
*
Dimension (b) is 71.8 mm (2.83 in) from the rear of the decal to the rear of the sheet metal in the tail lamp opening.
2. Warm the door surface with a J 25070, 152 mm (6 in) from the surface to a minimum of 21°C (70°F).
Important: Do not touch the adhesive backing on the decal.
3. Remove the backing from the front end of the decal.
4. Press the decal to the painted surface while continuing to remove the backing.
5. Hand roll the decal to the panel to ensure proper adhesion.
6. Inspect the decal for bonding.
7. Remove the tape from the area around the decal.
8. Install the tail lamp.
