Colorado 2WD V8-5.3L (2009)
4. Install the 2-4 servo assembly into the transmission.
5. Install the J 29714-A to the transmission oil pan flange.
6. Tighten the bolt in order to compress the servo cover.
7. Install the servo cover retaining ring.
8. Remove the J 29714-A .
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
9. Install the oil pan bolt and tighten to 11 Nm (97 lb in).
10. Install the heat shield (2).
11. Install the heat shield bolts (1) and tighten to 10 Nm (89 lb in).
12. Install the left catalytic converter. Refer to Catalytic Converter Replacement - Left Side (LH8) (See: Engine, Cooling and Exhaust/Exhaust
System/Catalytic Converter/Service and Repair/Catalytic Converter Replacement - Left Side).
13. Install the front propeller shaft. Refer to Front Propeller Shaft Replacement (See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller
