Workshop Repair Manuals

Chevrolet Workshop Manuals

[PREV PAGE] [NEXT PAGE]

chevrolet Workshop Repair Guides


Corvette V8-6.2L (2008)

Powertrain Management > Computers and Control Systems > Fuel Tank Pressure Sensor > Component Information > Service and Repair

Page 1
background image

Fuel Tank Pressure Sensor: Service and Repair

Fuel Tank Pressure Sensor Replacement

Removal Procedure

1. Remove the right rear wheelhouse panel. Refer to Rear Wheelhouse Liner Panel Replacement  (See: Body and Frame/Fender/Rear Fender/Rear

Fender Liner/Service and Repair) .

2. Remove the evaporative emission (EVAP) canister access cover.
3. Disconnect the fuel tank pressure sensor electrical connector.
4. Remove the fuel tank pressure sensor by carefully prying the sensor out of the fuel tank with a screwdriver.

Installation Procedure

1. Lubricate the fuel tank pressure sensor rubber grommet with clean engine oil in order to aid in installation.
2. Install the fuel tank pressure sensor into the top of the fuel tank.
3. Connect the fuel tank pressure sensor electrical connector.
4. Install the EVAP canister access cover.
5. Install the right rear wheelhouse panel. Refer to Rear Wheelhouse Liner Panel Replacement  (See: Body and Frame/Fender/Rear Fender/Rear

Fender Liner/Service and Repair) .

Powertrain Management > Computers and Control Systems > Fuel Tank Pressure Sensor > Component Information > Service and Repair

[PREV PAGE] [NEXT PAGE]