Corvette V8-6.2L (2008)
Installation Procedure
Caution: Refer to Fuel and EVAP Pipe Caution .
1. Route the EVAP purge pipe through the right tunnel brace opening.
2. Connect the EVAP purge pipe to the canister.
3. Remove the cap from the chassis EVAP purge pipe.
4. Connect the rear EVAP purge pipe (1) to the chassis EVAP purge pipe (3).
5. Install the EVAP vent valve (2) to the bracket (1).
6. For vehicles equipped with automatic transmission, install the right muffler. Refer to Exhaust Muffler Replacement - Right Side (See: Engine,
Cooling and Exhaust/Exhaust System/Muffler/Service and Repair) .
7. Install the EVAP canister access cover.
8. Install the right rear wheelhouse panel. Refer to Rear Wheelhouse Liner Panel Replacement (See: Body and Frame/Fender/Rear Fender/Rear
Fender Liner/Service and Repair) .
9. Lower the vehicle.