Chevrolet Workshop Manuals
Corvette V8-6.2L (2008)
Powertrain Management > Fuel Delivery and Air Induction > Fuel Injector > Component Information > Diagrams > Diagram Information and Instructions > Page 5039
2. Use a sewing seam ripper, available from sewing supply stores, in order to cut open the harness in order to avoid wire insulation damage.
Adjust splice locations so that each splice is at least 40 mm (1.5 in) away from the other splices, harness branches, or connectors.
4. Strip the insulation:
When adding a length of wire to the existing harness, use the same size wire as the original wire.
Perform one of the following items in order to find the correct wire size:
Find the wire on the schematic and convert the metric size to the equivalent american wire gage (AWG) size.
Use an AWG wire gage.
If you are unsure of the wire size, begin with the largest opening in the wire stripper and work down until achieving a clean strip of the
Strip approximately 7.5 mm (0.313 in) of insulation from each wire to be spliced.
Do not nick or cut any of the strands. Inspect the stripped wire for nicks or cut strands.
If the wire is damaged, repeat this procedure after removing the damaged section.
5. Slide a section of high temperature SCT1 shrink tubing down the length of wire to be spliced. Ensure that the shrink tubing will not interfere with
the splice procedure.
6. Select the proper DuraSeal splice sleeve according to the wire size. Refer to the above table at the beginning of the repair procedure for the color
coding of the DuraSeal splice sleeves and the crimp tool nests.
7. Use the Splice Crimp Tool from the J-38125 in order to position the DuraSeal splice sleeve in the proper color nest of the Splice Crimp Tool. The
crimp tool has three nests, 1 is for the salmon and green splice sleeve, 2 is for the blue splice sleeve, and 3 is for the yellow splice sleeve.
8. Place the DuraSeal splice sleeve in the nest. Ensure that the crimp falls midway between the end of the barrel and the stop. The sleeve has a stop
(3) in the middle of the barrel (2) in order to prevent the wire (1) from going further. Close the hand crimper handles slightly in order to firmly
9. Insert the wire into the DuraSeal splice sleeve barrel until the wire hits the barrel stop.
10. Tightly close the handles of the crimp tool until the crimper handles open when released.
The crimper handles will not open until you apply the proper amount of pressure to the splice sleeve. Repeat steps 4 and 5 for the opposite end of
|[PREV PAGE] [NEXT PAGE]|