Corvette V8-7.0L (2007)
5. Install the EVAP vent valve (2) to the bracket (1).
6. For vehicles equipped with automatic transmission, install the right muffler.
7. Install the EVAP canister access cover.
8. Install the right rear wheelhouse panel.
9. Lower the vehicle.
Evaporative Emission (EVAP) Hoses/Pipes Replacement - Engine (Tank/Tank)
Evaporative Emission Hoses/Pipes Replacement - Engine (Tank/Tank)
Tool Required
J 34730-1A Fuel Pressure Gage
Removal Procedure
1. Disconnect the negative battery cable.
2. Relieve the fuel system pressure. Refer to the Fuel Pressure Relief.
3. Drain the fuel tanks below the level of the fuel tank crossover hose. Refer to Fuel Tank Draining.
4. For vehicles equipped with automatic transmission, remove the left and right muffler.
