Corvette V8-7.0L (2007)
3. Install the boot (3) onto the inner tie rod assembly.
Important: The rack and pinion boot must not be twisted or out of shape in any way. An improperly shaped boot must be shaped by hand
before installing the boot clamp.
4. Install the boot (3) onto the gear assembly (1) until the boot is seated in the gear assembly groove.
5. Install the boot clamp on the boot (1) using tool J 22610 (2).
6. Crimp the boot clamp (2).
7. Install the tie rod end clamp on the boot using pliers.
8. Install the jam nut to the inner tie rod assembly.
9. Install the outer tie rod.
