Corvette V8-7.0L (2007)
Important: Use NEW transverse spring retainer-to-crossmember bolts.
3. Install the transverse spring retainers and NEW mounting bolts to the crossmember.
Tighten the bolts to 62 N.m (46 lb ft).
4. Install the lower control arm to the rear crossmember.
5. Remove the J 33432-A.
6. Install the tire and wheel assemblies.
7. If a NEW transverse spring was installed, adjust the rear trim height. Refer to Trim Height Inspection.
8. Perform a rear wheel alignment. Refer to Measuring Wheel Alignment.
