Corvette V8-7.0L (2007)
Suspension Spring ( Coil / Leaf ): Service and Repair
Front Suspension Leaf Spring
Front Transverse Spring Replacement
Tools Required
*
J 33432-A Transverse Spring Compressor
*
J 42188 Ball Joint Separator
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assemblies.
3. If the transverse spring is to be replaced, measure the front spring adjuster bolt gap (1).
This measurement will be used in the installation procedure to setup the vehicle trim height.
Notice: During this procedure, use care not to scratch the transverse spring.
4. Install the transverse spring compressor J 33432-A to the transverse spring.
5. Compress the transverse spring.
6. Remove the lower shock absorber mounting bolts from one of the lower control arms.
7. Disconnect the stabilizer shaft link from the lower control arm.
