Corvette V8-7.0L (2007)
Important: Do not separate the input shaft, propeller shaft, couplings, or bearing housing assembly, unless required. These components
are balanced as an assembly. Disassembly and improper reassembly of the components may cause vehicle driveline vibration.
If the input shaft, couplings, propeller shaft, or bearing housing assembly must be separated, the components must be marked prior to
disassembly. During assembly, the components must be returned to their original position and location.
1. Install the wave washer (1) into the rear bearing housing.
2. Lubricate the NEW rear bearing housing O-rings (1) with clean engine oil.
3. Install the O-rings into the rear bearing housing.
Important: Press only on the outer race of the bearing.
4. Position the rear bearing housing (2) into a press in order to install the bearing (1).
5. Install the bearing (1) into the housing.
