Equinox AWD V6-3.4L (2008)
6. Disconnect the rear park brake cables from the park brake actuators.
7. Using the J 37043 , remove the park brake cables from the mounting brackets
8. Position the rear park brake cables aside.
9. Disconnect the rear wheel speed sensor electrical connectors and routing clips from the rear support and upper control arms.
Position the wiring harness aside.
10. Remove the rear brake hose bracket nut and bolt.
Notice: Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible
brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which
may cause damage to the brake hose and in turn may cause a brake fluid leak.
11. Remove the brake calipers and brackets as assemblies and support them with heavy mechanics wire or equivalent. Refer to Rear Brake Caliper
Bracket Replacement .
12. While holding the stabilizer link with a wrench, remove the stabilizer link-to-lower control arm nut.
13. Remove the trailing arms. Refer to Trailing Arm Replacement (See: Trailing Arm/Service and Repair/Trailing Arm Replacement) .
14. Remove the adjustment links. Refer to Adjust Link Replacement (See: Steering/Tie Rod/Service and Repair) .
