Equinox AWD V6-3.4L (2008)
8. Rotate the control solenoid valve spring (7) into position.
Important: Install all bolts before tightening, then tighten in specified sequence.
9. Install the 4 control valve body bolts (1) M6 x 80.
10. Install the control valve body bolt (6) M6 x 55.
11. Install the 3 control valve body bolts (2) M6 x 95.
12. Install the control valve body bolt (3) M6 x 42.
13. Install the 2 control valve body bolts (4) M6 x 65.
14. Connect the input speed sensor electrical connector (1).
15. Connect the output speed sensor electrical connector (2).
16. Connect the shift position switch electrical connector (3).
17. Install the control valve body cover. Refer to Control Valve Body Cover Replacement (See: Control Valve Body Cover Replacement) .
18. For transmission control module programming and setup. Refer to Control Module References .
Important: After an internal transmission repair or internal part replacement the service fast learn adapt procedure should be
performed.
19. Perform the service fast learn adapt procedure. Refer to Service Fast Learn Adapts (See: Testing and Inspection/Component Tests and General
Diagnostics/6T70/6T75 - Automatic Transmission/Service Fast Learn Adapts) .
