Express 1/2 Ton Van V8-5.7L VIN R (1999)
8. Install the nut and the bolt that retains the wheel speed sensor harness bracket to the upper control arm.
-
Tighten the speed sensor retaining nut to 17 Nm (13 ft. lbs.).
9. Install the front brake caliper.
10. Install the tire and wheel assembly.
IMPORTANT: Check the running clearance at all of the suspension components.
11. Remove the safety stands.
12. Lower the vehicle.
13. Check the front wheel alignment. Refer to Wheel Alignment Specifications in Alignment.
With Light Duty Suspension
REMOVAL PROCEDURE
-
Tools Required
-
J 23742 Ball Joint Separator
1. Raise the vehicle. Support the vehicle with safety stands.
CAUTION: Floor jack must remain under the lower control arm during removal and installation to retain the lower control arm in position.
Failure to do so could result in personal injury.
2. Support the lower control arm with a floor jack.
3. Remove the tire and wheel assembly.
4. Remove the brake caliper.
