Express 1/2 Ton Van V8-5.7L VIN R (1999)
Control Arm Bushing: Service and Repair
REMOVAL PROCEDURE
-
Tools Required
-
J 9519-E Ball Joint Remover/Installer Set
1. Raise the vehicle. Support the vehicle with safety stands.
CAUTION: Floor jack must remain under the lower control arm during removal and installation to retain the lower control arm in position.
Failure to do so could result in personal injury.
2. Support the lower control arm with safety stands.
3. Remove the tire and wheel assembly.
4. Remove the upper control arm from the vehicle. Refer to Upper Control Arm Replacement.
5. Using the tools as shown remove the upper control arm bushings from the control arm.
Remove the tool.
INSTALLATION PROCEDURE
