Express 2500 V8-6.6L DSL Turbo (2010)
10. Remove the camshaft thrust plate bolts (1) through the holes in the camshaft gear (2).
11. In order to loosen the camshaft gear bolt use J-44643 - tool in order to hold the engine from turning.
Warning
The two piece cam gear must be bolted together to prevent the spring tension from unloading upon removal. Additionally, the two piece cam gear must
remain bolted together until it is re-installed to the camshaft and fully engaged to the crankshaft gear. Failure to do so may result in personal injury.
12. Loosen the camshaft gear bolt and leave the bolt finger tight.
13. Remove the camshaft thrust plate bolts through the holes in the camshaft gear.
14. Remove the camshaft (1) with the camshaft gear (2) attached.
