Express 2500 V8-6.6L DSL Turbo (2010)
15. Remove the camshaft gear bolt (1) and discard.
16. Remove the camshaft gear (2).
17. Remove the camshaft thrust plate (3).
18. Clean and inspect the camshaft and bearings. Refer to Camshaft and Bearings Cleaning and Inspection (See: Service and Repair/Overhaul/49.
Camshaft and Bearings Cleaning and Inspection).
If the camshaft bearings are worn or damaged the engine will require removal in order to replace the camshaft bearings. Refer to Engine
Replacement (See: Service and Repair/Removal and Replacement).
Installation Procedure
1. Install the camshaft thrust plate (3) to the camshaft.
2. Install the camshaft driven gear (2).
3. Install a NEW camshaft driven gear bolt (1).
Leave the bolt finger tight.
