Express 2500 V8-6.6L DSL Turbo (2010)
Battery Current Sensor: Service and Repair
Battery Current Sensor Replacement
Removal Procedure
1. Disconnect the instrument panel (I/P) harness electrical connector (1) from the battery current sensor.
2. Remove the negative battery cable. Refer to Battery Negative Cable Replacement (LMM -Primary) (See: Battery/Battery Cable/Negative/Service
and Repair/Battery Negative Cable Replacement (Primary)) Battery Negative Cable Replacement (V6) () Battery Negative Cable Replacement
(V8) () Battery Negative Cable Replacement (LGH - Primary) (See: Battery/Battery Cable/Negative/Service and Repair/Battery Negative Cable
Replacement (Primary)).
3. Cut the tie straps and electrical tape attaching the battery current sensor to the battery cable.
4. Squeeze the negative battery cable branches together.
Note: Note the position of the battery current sensor prior to removal.
5. Slide the battery current sensor (1) off of the negative battery cable.
Installation Procedure