Express 2500 V8-6.6L DSL Turbo (2010)
Note: Ensure that the tape tab is pointing away from the battery prior to installation.
1. Slide the NEW battery current sensor (1) up onto the negative battery cable.
2. Using NEW tie straps and electrical tape, attach the battery current sensor to the negative battery cable.
3. Install the negative battery cable. Refer to Battery Negative Cable Replacement (LMM -Primary) (See: Battery/Battery Cable/Negative/Service
and Repair/Battery Negative Cable Replacement (Primary)) Battery Negative Cable Replacement (V6) () Battery Negative Cable Replacement
(V8) () Battery Negative Cable Replacement (LGH - Primary) (See: Battery/Battery Cable/Negative/Service and Repair/Battery Negative Cable
Replacement (Primary)).
4. Connect the I/P harness electrical connector to the battery current sensor.