G 20 3/4 Ton Van V8-305 5.0L VIN H 4-bbl (1984)
3.
If the propshaft is not straight (e.g., center bearing support is offset to one side), the center bearing support should be relocated (See Illustration
#1).
4.
To relocate the hanger, support the propshaft with a jack stand, remove the center bearing hanger bolts, and move the bearing hanger (side to side)
to make the propshaft as straight as possible.
5.
Drill two new holes in the hanger support frame member and reinstall the bolts and torque to 15 - 22 N-m (20-30 ft.lbs.).
6.
Lower the vehicle and road test.
