HHR L4-2.4L (2010)
1. If equipped with a manual transaxle, perform the following steps, install the positive/negative battery cable (3) to the starter.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the starter solenoid nut (4).
Tighten the nut to 17 Nm (13 lb ft).
3. Install the positive/negative cable ground terminal (2) to the transaxle stud.
4. Install the positive/negative battery cable ground nut (1).
Tighten the nut to 10 Nm (89 lb in).
5. If equipped with a automatic transaxle, perform the following steps, install the positive/negative battery cable (3) to the starter.
6. Install the starter solenoid nut (4).
Tighten the nut to 17 Nm (13 lb ft).
