Impala V6-3.8L SC VIN 1 (2005)
1. Install the front bumper fascia lower support to the front bumper impact bar.
2. Install the push-in the retainers to the front bumper fascia lower support at the front of the bumper impact bar.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the screws to the lower front bumper fascia.
Tighten the screws to the lower front bumper fascia to 2 N.m (18 lb in).
Fascia Support Replacement - Front Bumper Upper (Impala)
Fascia Support Replacement - Front Bumper Upper (Impala)
Tools Required
J 38778 Door Trim Pad Clip Remover
Removal Procedure
1. Open the hood.
2. Remove the headlamps.
3. Remove the push-in retainers from the front bumper fascia upper support using J 38778.
4. Remove the front bumper fascia upper support bolts.