Impala V6-3.8L SC VIN 1 (2005)
Throttle Cable/Linkage: Service and Repair
Accelerator Controls Cable Bracket Replacement
ACCELERATOR CONTROLS CABLE BRACKET REPLACEMENT
REMOVAL PROCEDURE
1. Remove the fuel injector sight shield.
2. Remove the cruise control cable from the throttle body lever.
3. Remove the cruise control cable (1) from the bracket (2).
4. Remove accelerator cable from the throttle body lever.
5. Remove the accelerator cable (2) from the bracket (1).
6. Remove the accelerator controls cable bracket bolts.
7. Remove the accelerator controls cable bracket from the throttle body.
INSTALLATION PROCEDURE
NOTE: Do not route flexible components (hoses, wires, conduits, etc.) within 50 mm (2 in) of moving parts unless flexible components can be
securely fastened. This is necessary in order to prevent possible interference and damage to the component.
1. Install the accelerator controls cable bracket to the throttle body.
2. Install the accelerator controls cable bracket bolts.