Impala V6-3.8L SC VIN 1 (2005)
33. Route the deployment harness out of the driver side of the vehicle.
34. Disconnect the inflatable restraint I/P module connector, located at the RH side of the instrument panel.
35. Cut the 4 SIR wires leading to the connector from the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
IMPORTANT: If the vehicle is equipped with dual stage air bags, the steering wheel module and the I/P module will each have 4 wires. Refer to SIR
Connector End Views for determining the high and low circuits.
36. Strip 13 mm (0.5 in) of insulation from all 4 SIR wires connector leads.
37. Cut two 4.6 m (15 ft) deployment wires from a 0.8 mm (18 gage) or thicker multi-strand wire. These wires will be used for the I/P module
deployment harness.
38. Strip 13 mm (0.5 in) of insulation from both ends of the wires cut in the previous step.
39. Twist together 1 end from each of the wires in order to short the wires. Deployment wires shall remain shorted, and not connected to a power
source until you are ready to deploy the inflator module.