Impala V6-3.8L SC VIN 1 (2005)
IMPORTANT: If the vehicle is equipped with dual stage air bags, the steering wheel module and the I/P module will each have 4 wires. Refer to SIR
Connector End Views for determining the high and low circuits.
36. Strip 13 mm (0.5 in) of insulation from all 4 SIR wires connector leads.
37. Cut two 4.6 m (15 ft) deployment wires from a 0.8 mm (18 gage) or thicker multi-strand wire. These wires will be used for the I/P module
deployment harness.
38. Strip 13 mm (0.5 in) of insulation from both ends of the wires cut in the previous step.
39. Twist together 1 end from each of the wires in order to short the wires. Deployment wires shall remain shorted, and not connected to a power
source until you are ready to deploy the inflator module.
40. Twist together 2 connector wire leads, the high circuits from both stages of the I/P module, to one of the deployment harness wires. Refer to SIR
Connector End Views in order to determine the correct circuits.
41. Inspect that the 3 wire connection is secure.
42. Bend flat the twisted connection.
43. Secure and insulate the 3 wire connection to the deployment harness using electrical tape.